Draft
International Standard
ISO/DIS 17662
Welding — Calibration, verification and validation of equipment used for welding, including ancillary activities
Reference number
ISO/DIS 17662
Edition 3
Proyecto Norma internacional
Preview
ISO/DIS 17662
83737
No disponible en español
Este borrador de Norma Internacional se encuentra en la fase de consultas con los miembros de ISO.
Reemplazará ISO 17662:2016

ISO/DIS 17662

ISO/DIS 17662
83737
Idioma
Formato
CHF 63
Convertir Franco suizo (CHF) a tu moneda

Resumen

ISO 17662:2016 specifies requirements for calibration, verification and validation of equipment used for

- control of process variables during fabrication, and

- control of the properties of equipment used for welding or welding allied processes

where the resulting output cannot be readily or economically documented by subsequent monitoring, inspection and testing. This involves process variables influencing the fitness-for-purpose and in particular the safety of the fabricated product.

NOTE 1 This International Standard is based on the lists of process variables stated in International Standards for specification of welding procedures, in particular, but not exclusively in the ISO 15609‑ series. Future revisions of these International Standards can result in addition or deletion of parameters considered necessary to specify.

Some guidance is, in addition, given in Annex B as regards requirements for calibration; verification and validation as part of acceptance testing of equipment used for welding or allied processes.

Requirements to calibrate, verify and validate as part of inspection, testing, non-destructive testing or measuring of final welded products performed in order to verify confirm product compliance are outside the scope of the present International Standard.

The subject of this International Standard is limited to calibration, verification and validation of equipment after installation, as part of the workshops' and site operations for maintenance and/or operation.

It needs to be stressed that this International Standard has nothing to do with manufacture and installation of equipment for welding. Requirements for new equipment are formulated in directives and product codes (standards), as necessary.

Annex C provides information when other parties are involved in calibration, verification and validation activities.

Informaciones generales

  •  : En desarrollo
    : Cierre de la votación [40.60]
  •  : 3
     : 28
  • ISO/TC 44/SC 10
    25.160.30 
  • RSS actualizaciones

¿Tiene alguna duda?

Consulte nuestras Ayuda y asistencia