недоступно на русском языке

Тезис

 Предпросмотр

ISO 11666:2018 specifies two ultrasonic acceptance levels known as acceptance level 2 (AL 2) and acceptance level 3 (AL 3) for full penetration welded joints in ferritic steels, which correspond to ISO 5817:2014, quality levels B and C. An acceptance level corresponding to ISO 5817:2014, quality level D is not included in this document, as ultrasonic testing is generally not requested for this weld quality.

These acceptance levels are applicable to testing carried out in accordance with ISO 17640.

ISO 11666:2018 applies to the testing of full penetration ferritic steel welds, with thicknesses from 8 mm to 100 mm. It can also be used for other types of welds, materials and thicknesses, provided the tests have been performed with necessary consideration of the geometry and acoustic properties of the component, and an adequate sensitivity can be employed to enable the acceptance levels of this document to be applied. The nominal frequency of probes used in this document is between 2 MHz and 5 MHz, unless attenuation or requirements for higher resolution call for other frequencies. It is important to consider the use of these acceptance levels in conjunction with frequencies outside this range carefully.


Общая информация 

  • Текущий статус
     :  Published
    Дата публикации
     : 2018-01
  • Версия
     : 2
  • Технический комитет
     : ISO/TC 44/SC 5 Testing and inspection of welds
  • ICS
     :
    25.160.40 Welded joints and welds

Приобрести данный стандарт

Формат Язык
PDF + ePub
Бумажный
  • CHF92

Жизненный цикл


Появились вопросы?

Ознакомьтесь с FAQ

Работа с клиентами
+41 22 749 08 88

Часы работы:
Понедельник – пятница: 09:00-12:00, 14:00-17:00 (UTC+1)

Будьте в курсе актуальных новостей ИСО

Подписывайтесь на наши новости, обзоры, а также на информацию о продуктах.

  2. Интернет-магазин
  3. Каталог стандартов
  4. МКС
  5. 25
  6. 25.160
  7. 25.160.40
  8. ISO 11666:2018