Approved Work Item
ISO/AWI 12176-6
Plastics pipes and fittings — Equipment for fusion jointing polyethylene systems — Part 6: Electrofusion Control Unit (ECU) function testing
Reference number
ISO/AWI 12176-6
Edition 1
© ISO 2024
Approved Work Item
Under development
A working group has prepared a draft.

Abstract

This document specifies the type tests and the specific test methods for the control units (hereinafter called EUT – Equipment Under Test) operating with output voltage control that the manufacturer shall perform before placing the product on the market. It also specifies the tests that shall be performed after any service which has impact only over functional aspects and, in Annex A, the minimal content of the final test report. Electrical safety is out of the scope of this document. The outcome of the tests, as presented in the final test report, may be used by a conformity assessment body operating according to ISO/IEC 17021-1.

General information

  • Status
     : Under development
    Stage
    : New project registered in TC/SC work programme [20.00]
  • Edition
     : 1
  • Technical Committee :
    ISO/TC 138/SC 4
  • RSS updates

Life cycle

Sustainable Development Goals

This standard contributes to the following Sustainable Development Goals

6
Clean Water and Sanitation
7
Affordable and Clean Energy
8
Decent Work and Economic Growth
9
Industry, Innovation and Infrastructure
11
Sustainable Cities and Communities
13
Climate Action

Got a question?

Check out our Help and Support

  2. Store
  3. Standards catalogue
  4. TC
  5. ISO/TC 138/SC 4
  6. ISO/AWI 12176-6